How to solve the common problems of folding gluing machine belt and how to maintain it

folding gluing machine belt is a part used in the folding gluing machineequipment, which can effectively drive the equipment and drive the production of the equipment. Its importance is self-evident, but many customers will have various problems in the actual use of the folding gluing machine belt. So how should we deal with it?

How to solve the common problems of folding gluing machine belt maintenance

1. Slipping of the belt of the gluer should be tied to the belt with a wet cloth, and then pressed with the folded iron bar, or rubbed smooth with oil.

2. The belt of the gluer often falls off in this case mainly because the belt runs off, or because the length of the belt is too long. As long as the appropriate adjustment can be made.

3. belt on the glue treatment; belt in the purchase, its surface will have some trademark label sticky on it, this situation is very simple, as long as the use of warm water and towel for repeated wipe can be. Or use alcohol and gasoline also have these effects.

4. This folded part of the belt always run out of the belt to remove, find an object close to the drum one end set on the belt the other end also use the object close to the drum both ends fixed manual force asked after straightening, if the belt is not parallel to the following sagging, we call the trumpet joint is not handled well, if it is parallel that is the problem of the machine replace the new belt Note that the debugging at the beginning do not adjust too tight, adjust too tight if the Machine problems will also pull the tape bad, let the machine slowly adapt to the tape after the tightening.